Front door installation might appear challenging, but in reality, those with some DIY skills can easily replace an entry door. Simply acquire the right tools and follow this step-by-step guide to get started. Take care that you order doors that are both durable and energy efficient, as well as stylish.
Should you prefer professional installation for front doors Oakville, get in touch with your local windows and doors company. Most companies provide an extended warranty to cover any issues that may arise after the installation.
Front Door Installation Guide
Following is a list of tools needed for the front doors Oakville replacement:
- Tape measure
- Pen or pencil and paper
- Pry Bar
- Utility knife
- Measure the existing entry door and frame
The most critical part of the installation process is obtaining the correct measurement for the replacement front door. Using your tape measure, measure the height, depth, and width of the exterior door in question. Don’t forget the inner to the outer measurement of the door’s rough opening (the door minus the door jamb and door). Record the measurements from one trimmer to another and the header to the foot of the rough opening.
Bonus Tip: Measure at least two times and record once. This prevents errors that lead to the incorrect-sized door. This leads to delays as you need to reorder the door, which incurs extra time and costs.
- Take off the existing front door
Remove both the interior and exterior trim of the existing door using a pry bar between the door casing and wall. Next, use a screwdriver to remove the hinge pins. Then, from the house frame, take off the frame of the jamb. Lastly, using a pry bar, carefully remove the door frame.
- Fix the weatherproofing
Removing the old door often impacts the existing waterproofing. If you notice any damage, take a few moments to repair or replace the weather stripping.
- Prep the sill
Using lumber that has been treated, prep the sill. To ensure the sill plate remains level, use a 2-foot level.
- Install the front door frame
Firstly, use a bead of caulking before placing the door frame in the opening. Take care to follow the manufacturer’s directions. Using a 4-foot level, carefully ensure that the door frame is plum and square. Inspect the door to ensure proper functioning prior to nailing it in place via the door jambs and the shins,
- Insulate the entry door
To insulate the door, utilize an expanding foam between the jam and the frame. Keep in mind that this is not the final weatherproofing of the exterior door.
- Affix the Door Hardware and Casing
The next step involves installing the casing as well as any hardware. This includes handles, door knobs, deadbolts, etc.
Finish any exposed rough areas
For those doors with a raw finish, take the time to finish those edges that are exposed before sealing the bottom and top of the front doors Oakville.